Anti-Slip Sand

Stone Edge Surfaces Anti-Slip Sand helps provides increased slip prevention to sealers, epoxy, polyurea and polyaspartic floor coatings and systems, and can help provide a low cost, aggressive option to improve safety on wet slippery surfaces.

This Anti-Slip Sand is a natural aggregate (green product) pulled from Stone Edge Surfaces quarries, screened to a 50/70 mesh, then cleaned, dried and packaged to insure both quality and consistency.

Why Sand vs Other Anti-Slip Products?

Stone Edge Surfaces uses their own quarry, so this Anti-Slip Sand is a consistent color and quality. Sand adds a very tough slip resistance & texture profile to a surface. Sand also works well with high performance 2-part floor coatings.

Sand does not change physical properties of the coating. It can also be well bonded into the body of the coating.

MOST COMMON USES

Stone Edge Surfaces Anti-Slip Sand is typically broadcast into the top coat while wet and then back-rolled to insure each grain is fully encapsulated, but can also be applied over first coat of material and followed by a second coat of material.

APPLICATION

• BASE/TOP COAT: Top Coat
• APPLICATION METHOD: Mixed with or Cast over Sealers.
• WORKING TIME: Same as Sealers it is Being Used With.
• PRODUCTS USED WITH: Sealers

COVERAGE – SPREAD RATE

Typical spread rates can average 1 LB for every 100 sqft for residential to 1 LB every 50 sqft for commercial applications where safety requirements are much higher.

 

Anti-Slip Sand comes in 50 LB Bags.